Electrolux FAC124P1A Instruções de Operação descarregar pdf (Página 99)

Section 4 Component Teardown

4-39

Fan and Blower Assembly Removal

To remove the fan and blower assembly:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

Remove the control panel from its installation

position but do not disconnect from wire harness.

Remove the top two styrofoam sections of the

blower compartment.

3. Discharge capacitor. To discharge the high voltage

capacitor, wait for 60 seconds and then short-circuit

the connection of the high-voltage capacitor (that

is the connecting lead of the high-voltage rectifier)

against the chassis with the use of an insulated

screwdriver.

4. The fan motor wire harness passes through the

control system bulkhead. Disconnect the fan motor

wire leads from the capacitor and control board.

Remove ground wire from control system bulkhead.

5. Pull fan motor wire harness through hole in control

system bulkhead.

6. Extract the 3 screws from each side of condenser,

then extract the two screws from the top of the

condenser. (See Figure 4-100)

7. Extract the two screws securing the bottom of the

fan and blower assembly to the unit base.

(See Figure 4-100)

8. Use either a 10 mm extended socket of a long

phillips head screwdriver and extract the four screws

securing the fan motor mounting bracket to the unit

base. (See Figure 4-100)

9. Carefully lift the fan and blower assembly upwards

until free of condenser.

Assembly Breakdown

10. Use an 16mm socket or wrench and remove the nut

securing the blower to the fan motor shaft. Remove

the lock washer and washer from shaft. Pull blower

from motor shaft. (See Figure 4-101)

11. Use a 13mm socket or wrench and remove the left

hand nut and lock washer securing the fan blade

to the fan motor shaft. Pull the fan blade from the

motor shaft. (See Figure 4-102)

12. Use a phillips head screwdriver or an 8 mm wrench

or socket and extract the 3 screws securing the fan

motor to the mounting bracket. The fan motor is

now free. (See Figure 4-103)

Figure 4-103.

Figure 4-100.

Remove

Screws

Repeat

Opposite Side

Remove

Screws

13 mm Nut

Left Hand

Thread

Figure 4-102.

Figure 4-101.

16 mm Nut

Right Hand

Thread

Remove

Screws

Repeat

Opposite Side

Of Bracket

Screws

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 139 140

Comentários a estes Manuais

Sem comentários

Electrolux FAC124P1A Instruções de Operação Página 99

Comentários a estes Manuais

Manuais e produtos relacionados com Aparelhos de ar condicionado "split system" Electrolux FAC124P1A