Electrolux FAC124P1A Instruções de Operação descarregar pdf (Página 102)

Section 4 Component Teardown

4-42

Figure 4-107.

Model FAA (Mini-Compact) Series

Filter And Front Panel Assembly Removal

1. Disconnect the power supply from unit.

2. Push the vent handle to the vent closed position

(where applicable).

3. Open the front grille panel by using both hands,

grabbing along the sides of the unit and pulling the

top of the front grille panel away from the unit until

the retaining tabs release from the front panel. Tilt

the front grille panel away from the unit.

4. Grasp the filter in the center and pull out of unit.

5 . Pull the front grille panel out from the slots at the

bottom corners of the unit frame.

6. Extract the four screws securing the front panel to

the unit frame. (See Figure 4-107)

7. Remove the front panel by pulling the outer edges

away from the unit frame until the tabs are free of

the slots in the unit frame. (See Figure 4-108 Arrows

show the tab locations) Release the two side tabs

first then lift the front panel upwards until the front

panel is free.

8. Turn front panel to access the ionizer cable, using

caution not to strain the wire harness connections.

Remove ionizer cable from the retainers on the back

side of the front panel. (See Figure 4-109)

User Interface Removal

The user interface can be removed from the front panel

by extracting the 3 screws as shown in Figure 4-110,

however, the user interface wiring harness will still be

connected to the control panel. Accessing the control

panel will be covered on page 4-43.

To remove the user interface:

1. Disconnect power supply from unit.

2. Follow the steps above for front panel removal.

3. Extract the three screws, then turn the user interface

and push through front panel. Front panel is now

free. (See Figure 4-110)

Figure 4-108.

Use caution not to strain wire harness connections.

The user interface and ambient thermistor are still

connected to the wiring harness and can only be

disconnected at the inner control board.

CAUTION

Figure 4-109.

Ionizer

Wire Retainers

Screws

Tab

TabTab

Due to the number of models within the series, some

teardown procedures, such as locations and number of

fasteners, and location of electrical system components,

may vary from the descriptions given in this section.

Always use the wiring diagram attached to the unit for

all electrical connections.

NOTE

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 139 140

Comentários a estes Manuais

Sem comentários

Electrolux FAC124P1A Instruções de Operação Página 102

Comentários a estes Manuais

Manuais e produtos relacionados com Aparelhos de ar condicionado "split system" Electrolux FAC124P1A