
Section 4 Component Teardown
4-26
Top Condenser Fan Cover Removal
1. Disconnect the power supply from unit.
2. Remove front panel and cabinet wrapper/sleeve.
3. Pull condenser fan cover off condenser assembly.
Condenser Fan Shroud/ Fan and Blower Assembly
Removal
To remove the condenser fan shroud with the fan and
blower assembly:
1. Disconnect the power supply from unit.
2. Remove front panel and cabinet wrapper/sleeve.
3. Pull condenser fan cover off condenser assembly.
4. Disconnect the compressor and condenser fan motor
wire harness connections from the control box
components. Free wire harness from condenser fan
shroud.
5. Extract screw from back side of bulkhead that
secures the condenser fan shroud to the bulkhead.
(See Figure 4-65)
6. Extract the three screws along the left side of the
condenser securing the condenser fan shroud in
position. (See Figure 4-66)
7. Pull the condenser fan shroud with the fan and
blower assembly upwards from the unit base and
remove from unit.
Fan And Blower Assembly Breakdown
To remove the blower wheel:
1. Disconnect power supply from unit.
2. Remove the front panel assembly. Pull the unit from
the cabinet wrapper/sleeve.
3. Remove the condenser fan assembly from the unit.
Remove the front styrofoam section of the air duct.
4. Use a 16mm socket or wrench and remove the nut
securing the blower wheel to the motor shaft. Pull
the lock washer and washer off shaft, then pull
blower wheel off shaft. (See Figure 4-67)
5. The rear section of the styrofoam air duct may now
be removed from the bulkhead partition.
Figure 4-65.
Screw
Figure 4-66.
Screws
Figure 4-67.
Front Blower
Housing
Rear Blower
Housing
Blower
16mm Nut
Comentários a estes Manuais