Electrolux FAC124P1A Instruções de Operação descarregar pdf (Página 31)

Section 2 Installation

2-1

Models FAA, FAC and FAX Room Air

Conditioner Installation Instructions

Model FAA, FAC and FAX air conditioners are designed

to install in standard double hung windows with opening

widths of 23 to 36 inches (584 mm to 914 mm)

(See Figure 2-1)

Lower sash must open sufﬁ ciently to allow a clear vertical

opening of 14-1/4” inches (356 mm). The FAX series

only requires a 13” (330 mm) vertical opening. Side

louvers and the rear of the RAC unit must have clear air

space to allow enough airﬂ ow through the condenser for

heat removal. The rear of the unit must be outdoors, not

inside a building or garage.

Mounting Hardware Tools Needed

3/4” Screws Qnty 7 Phillips Screwdriver

Lock Frame Qnty 2 Drill (For pilot holes)

Sash Lock Qnty 1

Before installing unit, the top rail must be assembled on

the unit.

Top Rail Hardware Tool Needed

3/8” Screw Qnty 4 Phillips Screwdriver

Top Rail Qnty 1

1. Remove air conditioner from carton and place on a

flat surface.

2. Remove top rail from packaging material.

3. Align the hole in the top rail with those in the top of

the unit then secure with the 3/8” screws.

(See Figure 2-2)

How to Install

1. Place unit on floor, a bench or table. There is a

left and right window filler panel, be sure to use

the proper panel for each side. When installed, the

flange for securing the panel to the window sill will

be facing into the room.

A. Hold the accordion filler panel in one hand and

gently pull back the center to free the open end.

(See Figure 2-3)

B. Slide the free end (“I” section) of the panel into

the cabinet as shown in Figures 2-4, 2-5 and

2-6. Slide the panel down. Be sure to leave

enough space to slip the top and bottom of the

of the frame into the rails on the cabinet.

Exterior

Wall

Offset

Stool Sill

Interior

Wall

23” to 36”

584mm to 914mm

14-1/4”min.

(337mm)

Do not use any screws other than those specified here.

NOTE

For safety reasons, all four (4) screws must be securely

fastened.

NOTE

Top Rail and Sliding Panels at each side are offset to

provide the proper pitch to the rear of (5/16”). This is

necessary for proper condensed water utilization and

drainage. If you are not using the Side Panels for any

reason, this pitch to the rear must be maintained!

NOTE

When handling unit, be careful to avoid cuts from

sharp metal edges and aluminum fins on front and rear

coils.

CAUTION

Screws (4)

Top Rail

Figure 2-1.

Figure 2-2.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 139 140

Comentários a estes Manuais

Sem comentários

Electrolux FAC124P1A Instruções de Operação Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Aparelhos de ar condicionado "split system" Electrolux FAC124P1A