Electrolux GHGL4046CN Manual de Instalação descarregar pdf (Página 7)

5. Slide the unit along the worktop.

Fasten the unit in the cut-out using

the six screws (6) provided. Use

three screws at each side.

66

• In case of a 490 mm deep cut-out,

move the unit forward along the

worktop until it stops.

• In case of a 504 mm cut-out, push

the unit to the end and then move

it back towards yourself by 7 mm.

6. Put the hob back on the cooking

surface and adjust the burners. Make

sure that the hob does not rise above

the surrounding worktop surfaces.

1.12 Installing the metal burner

plate

1. Place the hob in the cut-out.

2. Secure the hob in place using the 4

screws. Place the screws in the

proper holes and secure them with

spinlock nuts.

3. The 4 burners have to be positioned

in their places without any pressure,

with a very slight pressure towards

the top.

4. Secure the burners into their places

on the burner plate with 2 screws

each.

5. Screw the burner plate to the worktop

with a screw in each side, going

through the oval holes for the pan

support.

The screws have to be screwed in

very tight in order to secure the

connection.

6. Install the burner crowns, burner

caps and the pan support.

Make the final check whether the

appliance functions correctly and the gas

installation is safe.

1.13 Installing the glass burner

plate

A) Installation on top of the

appliance.

1. Trace the dimensions of the hob on

the worktop with a pencil or a water-

soluble felt tip pen. Lift the hob and

put it away.

2. Place the rubber self-adhesive seal

inside the drawn outline,

approximately 2 mm from the edge.

The seal must stick to the surface of

the furniture and there cannot be any

gaps in the outline.

ENGLISH

7

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários