Electrolux GHGL4046CN Manual de Instalação descarregar pdf (Página 4)

2. Secure the plate with two screws.

1.8 Electrical connection

Standard socket, type 13.

The electrical installation must have an

isolation device which lets you disconnect

the appliance from the main power supply

at all poles. The isolation device must have

a contact opening width of minimum 3

mm.

Use only correct isolation devices: line

protecting cut-outs, fuses, earth leakage

trips and contactors. Screw type fuses

must be removed from the holder.

Before the connection make sure that the

voltage on the rating plate, nominal

voltage of the oven, agrees with the power

supply. The rating plate can be found on

the frame of the appliance, open the door

to access it.

The voltage of the heaters is 230 V AC,

but the appliance can also function

correctly on the 220 V AC.

The electrical cable cannot touch the back

wall of the built-in appliance.

The socket must be easily accessible.

1

2

1. Gas connection

2. Rating plate

1.9 Build-in gas hob

GKM45GLAS and GKM45CN

Prepare the cut-out in the worktop to

place the hob:

• The cut-out should be placed in the

center of the worktop where the

appliance is installed.

• Make the cut-out in the worktop

according to the dimensions

presented below. Too deep cut-out

must be corrected for example by a

wooden surround.

• Seal the cut surface with an

appropriate heat resistant sealant to

protect it from humidity.

• Preserve the minimal distances:

– 100 mm on any side to the

nearest piece of furniture,

– 100 mm at the back of the

worktop cut-out to the rear edge

of the worktop,

– 560 mm from the surface of the

hob to the piece of furniture /

appliance above it.

www.electrolux.com4

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários