Electrolux GHGL4046CN Manual de Instalação descarregar pdf (Página 3)

of the parts near the oven. Contact the

furniture producer in case of any doubts.

This appliance of the third class is

designed to be built-in in kitchen furniture.

The wall behind the appliance and wall of

the piece of furniture next to it can have

any height.

The piece of furniture on the other side

must be on the same level as the hob.

Keep the required minimal distances as

measured in relation to the hob:

• 100 mm on any side to the nearest

piece of furniture,

• 100 mm at the back of the worktop

cut-out to the rear edge of the

worktop,

• 560 mm from the surface of the hob to

the piece of furniture / appliance

above it.

1.7 Gas connection

The gas pipe gasket is in a

bag inside the oven.

Check the factory settings of the

appliance on the rating plate.

The appliance is set for natural gas H 20

mbar.

In case of conversion to different type of

gas, the label should be taken off and

replaced with a new technical label with

the correct data.

The connection to the gas supply should

be permanent.

The appliance should be connected by a

steel-only hose fitted with a safety device

and with a homologation of SGWA (Swiss

Gas and Water Industry Association).

100

5

A min. 550

B 565

C 600

95

2

3

20

x = 20

A 594 +0/-1

N 600

4

1. Cut-out at the bottom to carry out all

the installation works without

difficulties

60

60

60

460

20-50 R

1

2. G 1/2" coupler installed at the

bottom, to be installed with at least a

flange.

3. Valve to cut off the gas G1/2.

4. Metal tube 150 cm with G1/2 internal

thread, connected to the valve

through a gasket.

Gas protection installation

Install the protection to secure the gas

pipe.

1. Place the metal cover plate over the

pipe.

ENGLISH

3

1 2 3 4 5 6 7 8 ... 11 12

Comentários a estes Manuais

Sem comentários