Electrolux EHD60100P Manual do Utilizador descarregar pdf (Página 10)

To remove the dirt:

1. – Remove immediately:melted plas-

tic, plastic foil, and food with sugar. If

not, the dirt can cause damage to the

appliance. Use a special scraper for

the glass . Put the scraper on the

glass surface at an acute angle and

move the blade on the surface .

–

Remove after the appliance is suf-

ficiently cool:limescale rings , water

rings, fat stains, shiny metallic discol-

orations. Use a special cleaning agent

for glass ceramic or stainless steel.

2. Clean the appliance with a moist cloth

and some detergent.

3. At the end rub the appliance dry with

a clean cloth.

WHAT TO DO IF…

Problem Possible cause and remedy

You cannot activate the appli-

ance or operate it.

•

The key lock or child safety device operates

. Stop the

function. Refer to "Lock" and "The Child safety device".

•

STOP+GO operates

. Stop the function. See the section

"Stop and go".

• You touched 2 or more sensor fields at the same time. Only

touch one sensor field.

• There is water or fat stains on the control panel. Clean the con-

trol panel.

• Start the appliance again and set the heat setting in less than

10 seconds.

An acoustic signal sounds

when the appliance is off.

You covered one or more sensor fields. Uncover the sensor

fields.

An acoustic signal sounds 6

times and the appliance deacti-

vates.

You covered one or more sensor fields. Uncover the sensor

fields.

The residual heat indicator

does not come on.

The cooking zone is not hot because it operated only for a short

time. If the cooking zone must be hot, speak to the Service Cen-

tre.

The automatic warm up func-

tion does not start.

•

The cooking zone is still hot (residual heat

). Let the cooking

zone cool down.

• The highest heat setting is set. The highest heat setting has the

same power as the automatic warm up function.

An acoustic signal sounds. The

appliance activates and deacti-

vates again. After 5 seconds

the acoustic signal sounds

again.

You covered . Uncover the sensor field.

The sensor fields become hot. The cookware is too large or you put it too near the controls. Put

large cookware on the rear cooking zones if necessary.

The display changes between 2

heat settings.

Power Management decreases the power of this cooking zone.

Use cooking zones on the other side.

comes on.

• The automatic switch-off operates. Deactivate the appliance

and activate it again.

Overheating protection for the cooking zone operates. Deactivate

the cooking zone and activate it again.

10 electrolux

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

Electrolux EHD60100P Manual do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Electrolux EHD60100P