
CLEANING FUNCTION
1.
Touch
. Each zone is set to 80°C.
The display flashes until the tempera-
ture is 80°C. The function locks the
control panel, but not
.
2. When the temperature is 80°C, an
acoustic signal sounds, and the control
panel becomes unlocked.
3. Put ice cubes one by one on the roast-
ing zone (you can use also cold water).
At the same time, use a spatula to re-
move the remaining roasting pieces
and push all pieces into the trough.
4. Dry the appliance with a clean cloth.
CLEANING WHEN THE APPLIANCE IS
COLD
1. Apply a usual cleaning agent to the
roasting surface and let it set for 5 mi-
nutes.
2. Remove the cooking residue with a
spatula.
3. Clean the appliance with a moist cloth
4. Dry the appliance with a clean cloth.
5. When the appliance is dry, rub the
roasting surface with some cooking oil.
TROUBLESHOOTING
Problem Possible cause Remedy
You cannot activate the appli-
ance or operate it.
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
Check if the appliance is cor-
rectly connected to the electri-
cal supply (refer to connection
diagram).
Activate the appliance again
and set the heat setting in less
than 7 seconds.
You touched 2 or more sensor
fields at the same time.
Touch only one sensor field.
There is water or fat stains on
the control panel.
Clean the control panel.
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds
when the appliance is deactiva-
ted.
You put something on one or
more sensor fields.
Remove the object from the
sensor fields.
The appliance deactivates. You put something on the sen-
sor field
.
Remove the object from the
sensor field.
The residual heat indicator
does not come on.
The roasting zone is not hot
because it operated only for a
short time.
If the roasting zone operated
sufficiently long to be hot,
speak to the service centre.
There is no signal when you
touch the panel sensor fields.
The signals are deactivated. Activate the signals (refer to
“OffSound Control”).
comes on
The Automatic Switch Off oper-
ates.
Deactivate the appliance and
activate it again.
comes on
The Child Safety Device or the
Lock function operates.
Refer to the chapter “Daily
Use”.
and number come on.
There is an error in the appli-
ance.
Disconnect the fuse from the
electrical system of the house
in order to disconnect the ap-
pliance from the electrical sup-
ply for some time. Connect it
again. If
comes on again,
speak to the service centre.
electrolux 59
Comentários a estes Manuais