Electrolux FEH50P2 Manual do Utilizador descarregar pdf (Página 22)

adjust the side measurement to

centre the appliance.

If you changed the

dimensions of the cooker,

you must align the non-tip

device correctly.

CAUTION!

If the space between the

bench cupboards is larger

than the width of the

appliance, you must adjust

the side measurement to the

centre of the appliance.

14.5 Electrical installation

WARNING!

The manufacturer is not

responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied without a main

plug or a main cable.

Applicable cable type: H05 RR-F with

adequate cross-section.

WARNING!

Before you connect the

mains cable to the terminal,

measure the voltage

between phases in the

house network. Then, refer

to the connection label at the

back of the appliance to use

the correct electrical

installation. This order of

steps prevents from

installation errors and

damage to the electrical

components of the

appliance.

WARNING!

The power cable must not

touch the part of the

appliance shown in the

illustration.

15. ENERGY EFFICIENCY

15.1 Hob - Energy saving

You can save energy during everyday

cooking if you follow below hints.

• When you heat up water, use only the

amount you need.

• If it is possible, always put the lids on

the cookware.

• Before you activate the cooking zone

put the cookware on it.

• The cookware bottom should have the

same diameter as the cooking zone.

• Put the smaller cookware on the

smaller cooking zones.

• Put the cookware directly in the centre

of the cooking zone.

www.electrolux.com22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários