Electrolux EKK6130AOW Manual do Utilizador descarregar pdf (Página 30)

12.12 Adjustment of minimum

level at the hob burner

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-

pass screw position (A). The bypass

screw position (A) depends on model.

A

• If you change from natural gas to

liquid gas, fully tighten the

adjustment screw.

• If you change from liquid gas to

natural gas, undo the by-pass

screw approximately 1/4 of a turn

(1/2 of a turn for the Triple Crown

burner).

WARNING!

Make sure the flame does not

go out when you quickly turn

the knob from the maximum

position to the minimum

position.

12.13 Levelling of the appliance

Use small feet on the bottom of appliance

to set the appliance top surface level with

other surfaces.

12.14 Anti-tilt protection

CAUTION!

Install the anti-tilt protection

to prevent the appliance from

falling under incorrect loads.

The anti-tilt protection only

works when the appliance is

put in a correct area.

Your appliance has the

symbols shown on the

pictures (if applicable) to

remind you about the

installation of the anti-tilt

protection.

CAUTION!

Make sure you install the anti-

tilt protection at the correct

height.

Make sure that the surface behind the

appliance is smooth.

1. Set the correct height and area for the

appliance before you attach the anti-

tilt protection.

2. Install the anti-tilt protection 77 mm

down from the top surface of the

appliance and 49 mm from the left

side of the appliance into the circular

hole on the bracket. See the

illustration. Screw it into the solid

www.electrolux.com30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comentários a estes Manuais

Sem comentários