Electrolux F43GXE Manual do Utilizador descarregar pdf (Página 21)

12.3 Oven injector replacement

1. Remove the bottom plate of the oven

cavity (A) to get access to the oven

burner (B).

AB

2. Release the screw (C), which keeps

the burner in position.

C

3. Carefully move the burner off the

injector support (D).

D

E

F

4. Slowly move it to the left side. Do not

apply force to the wire of the spark

plug connector (F) and to the

thermocouple conductor (E).

5. Release the burner injector (D) with a

7 mm socket spanner and replace it

with a different one which is

necessary for the type of gas you

use.

Refer to “Technical information”

chapter.

6. Assemble the burner in a reverse

sequence.

Replace the gas type sticker near the

gas supply ramp with the one related to

the new gas type.

The gas oven burner does not need any

primary gas regulation.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values.

If the supply gas pressure is

changeable or different from

the necessary pressure, you

must fit an applicable

pressure adjuster on the gas

supply pipe.

12.4 Building in

• Only set up the appliance in a kitchen

or in a kitchen-dining room. Do not set

up the appliance in a bathroom or a

bedroom.

• You can install the appliance "built-in"

or "built-under". The dimensions of

the built-in cabinet must agree with

the related illustrations.

ENGLISH 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários