Electrolux EKK601304W Manual do Utilizador descarregar pdf (Página 21)

3. Using a socket spanner 7 unscrew and

remove the nozzles replacing them with

the ones required for the kind of gas in

use (see table " Burner characteristics " ).

AC

B

If changing to gas G2.350, after nozzle

replacement (letter B), cover the nozzle

with air regulator. For semi-rapid and

auxiliary burner use air regulator marked

as A (dimension 10). For rapid burner

use air regulator marked as C (dimen-

sion 16).

4. Reassemble the parts following the same

procedure backwards.

5. Replace the rating label (placed near the

gas supply pipe) with the relevant one for

the new type of gas supply. You can find

this label in the package of the injectors

supplied with the appliance.

These burners do not need any primary air

regulation.

Adjustment of minimum level

To adjust the minimum level of the burners,

proceed as follows:

1. light the burner;

2. turn the knob on the position of minimum

flame;

3. remove the knob;

4. with a thin screwdriver, adjust the bypass

screw;

If changing from natural gas G20 20

mbar to liquid gas G30/31 37 mbar,,

completely tighten the adjustment screw

in, until a small regular flame is obtained.

If changing from liquid gas G30/31 37

mbar to natural gas G20 20 mbar, undo

the by-pass screw about 1/2 of a turn.

If changing from natural gas G20 20

mbar to natural gas G2.350 13 mbar un-

do the by-pass screw about 1/4 of a

turn.

If changing from liquid gas G30/31 37

mbar to natural gas G2.350 13 mbar,

undo the by-pass screw about 3/4 of a

turn.

Reassemble the parts following the same

procedure backwards.

Finally, check the flame does not go out

when quickly turning the knob from the max-

imum position to the minimum position.

Electrical connection

The unit is preset to work with a voltage of

single phase 230 V.

Before making the connection make sure

that:

• the energy power available in the user's

house is sufficient for the normal supply of

this appliance (see rating plate)

• the unit is correctly connected to earth

through a suitable plug and according to

the installation country Laws

• the socket or the omnipolar switch used

for the connection must be easilv reached

with the installed appliance

The appliance is supplied with electric cable,

therefore you will have to fit it with a standard

plug, suitable for the total electric load shown

electrolux 21

1 2 ... 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários