Electrolux FOM 71 CLS Manual do Utilizador descarregar pdf (Página 12)

3:2

Installation inspection of the reference machine

5330

1

Drain connection

• Connect a 75 mm (2 1/2") ﬂexible rubber hose

to the machine’s drain pipe, ensuring a down-

ward ﬂow from the machine. Avoid sharp

bends, which may prevent proper drainage.

• There should be an air-gap of 50 mm between

the drain hose and the drain.

• Make sure that the drain hose is sufﬁciently

ﬂexible so that it does not cause problems

related to the scale system.

• Pipes made from PVC or similar materials

may not be connected to the machine due to

the load cells.

• The drainage hose should be located over a

ﬂoor drain, drainage channel or similar so that

the distance between the outlet and the drain

is at least 25 mm (1").

• Checkthattheamountofsupplywateratthe

water connection to the reference machine is

sufﬁcient and compliant with the speciﬁca-

tion in the standard (15 ± 2 litre) and that the

amount can be maintained at all times. The

water pressure at the intake of the machine

may never fall below 100kPa.

• Checkthatthepowersupplyiscompliantwith

the voltage speciﬁed on the reference machi-

ne data label and within the tolerances of the

standard (± 2%) .

• Makesurethatthepowersupplycanmaintain

the required voltage level whilst the reference

machine is heating.

1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 163 164

Comentários a estes Manuais

Sem comentários