Electrolux FOM 71 CLS Manual do Utilizador descarregar pdf (Página 11)

3:1

Installation inspection of the reference machine

5710 A

1

Wascator FOM 71 CLS

Installation inspection of the

reference machine

Before carrying out any major test series inspect

the installation and check the following terms:

• Themachinemustbeinstalledonalevel

base. The following clearances are recom-

mended in order to facilitate calibration:

At least 500 mm between the machine and

the wall behind and min. 50 mm on both

sides of the machine whether installed next to

the wall or other machines.

• Checkthelevellingofthemachine.Theverti-

cal difference from corner to corner of the top

lid shall not exceed 5 mm. If not adjust the

feet of the machine.

• Themachineshallbeconnectedusingthe

supplied Y hose or using two single hoses.

• Thewaterhoseandpowercablemusthang

freely between the machine and wall in order

to prevent disrupting the reference machine

scale system.

• Makesurethatthedraininstallationismade

according to the information on next page.

Observe the required air gap in the drain sys-

tem.

50 mm

500 mm

1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 163 164

Comentários a estes Manuais

Sem comentários