Electrolux EKK603504X Manual do Utilizador descarregar pdf (Página 31)

electrolux 31

Adaptation to different kinds of gas

To adapt the appliance to a different kind of

gas from the one the appliance has been set for,

follow the instructions below in their order.

Gas connection

LPG: use the rubber pipe holder «D».

Natural gas : use the pipe holder «E».

Always insert the gasket sealing «B». Then

proceed with the gas connection, as indicated in

the relevant paragraphs.

Hob burners nozzles

1. Nozzles replacement

1. Remove the pan supports.

2. Extract the caps and the wall baffles of the

burners.

3. Using a socket spanner 7 unscrew and

remove (see diagram) the nozzles replacing

them with the ones required for the kind of

gas in use (see table “Burner characteris-

tics”).

4. Reassemble the parts following the same

procedure backwards.

5. Replace the rating label (placed near the gas

supply pipe) with the relevant one for the

new type of gas supply. You can find this

label in the package of the injectors supplied

with the appliance.

These burners do not need any primary air

regulation.

2. Adjustment of minimum level

To adjust the minimum level of the burners,

proceed as follows:

1. light the burner;

2. turn the knob on the position of minimum

flame;

3. remove the knob;

4. with a thin screwdriver, adjust the by-pass

screw (see diagram).

• If changing from natural gas 20 mbar/13

mbar to liquid gas, completely tighten the

adjustment screw in, until a small regular

E

B

D

A

A Gas connection point

B Gasket

C Adjustable connection

D LPG rubber pipe holder

E Natural gas pipe holder

C

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Comentários a estes Manuais

Sem comentários