Electrolux EHG7765X Manual do Utilizador descarregar pdf (Página 12)

Fitting the hob to the worktop

The hob can be installed in a kitchen unit with an opening

for insertion whose dimensions are shown in Fig. 12. To

install the hob, proceed as follows:

1) Place the seals supplied with the hob on the front

edge of the cut out. Then, place them at 50 mm from

the side edges and at 10 mm from the rear edge, as

shown in the diagram, taking care that the sealings

meet without overlapping (Fig. 10).

2) Place the hob in the cut out, taking care that it is

centred.

3) Fix the hob with the relevant screws (Fig. 11). The

traction of the screws is able to trace the sealing, any

excess of which can be easily removed.

The edge of the hob forms a double labyrinth seal which

provides a total guarantee against infiltration of liquids.

This hob can be inserted in a built-in kitchen unit whose

depth is between 550 and 600 mm. The hob dimensions

are shown in figure 9.

The edge of the cut out must have a minimum distance

from the rear wall of 55 mm.

If there are side walls, or sides of the furniture unit near

the hob, the cut out edges must have a minimum

distance of 150 mm.

TC = Triple crown burner

R = Rapid burner

SR = Semirapid burner

A = Auxiliary burner

Building In

510

680

Fig. 11

a) Sealing gasket

Fig. 10

Fig. 9

Dimensions are given in millimeters

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sem comentários

Electrolux EHG7765X Manual do Utilizador Página 12