Electrolux EGT6343LOK Manual do Utilizador descarregar pdf (Página 12)

Model .......................................

PNC .........................................

Serial number ...........................

8.2 Nozzles replacement

WARNING!

The gas settings of this

appliance are not applicable

for Cyprus. If you install this

appliance in Cyprus, you

must change the nozzles

before you connect the

appliance. To change the

nozzles refer to the type of

gas used. See the tables in

the “Technical Information”

chapter for more information.

8.3 Gas Connection

WARNING!

The following instructions

about installation, connection

and maintenance must be

carried out by qualified

personnel in compliance with

standards and local

regulations in force.

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values. The

adjustable connection is fixed

to the comprehensive ramp

by means of a threaded nut

G 1/2". Screw the parts

without force, adjust the

connection in the necessary

direction and tighten

everything.

A B C

A) End of shaft

B) Washer

C) Elbow (if needed)

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but

shows its correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is complete,

make sure that the seal of

each pipe fitting is correct.

Use a soapy solution, not a

flame!

8.4 Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

www.electrolux.com12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários