Electrolux GHL246SW Manual de Instalação descarregar pdf (Página 4)

(Swiss Gas and Water Industry

Association).

1

2

3

N 550

A 548 +0/-1

min. 50

A 572

N 600

20

1. G 1/2" coupler installed at the height

of 160 mm from the ground, to be

installed with at least a flange.

2. Valve to cut off the gas G1/2.

3. Metal tube 50 cm with G1/2 internal

thread, connected to the valve

through a gasket.

160

1

2

1. Gas connection

2. Rating plate

Gas protection installation

Install the protection to secure the gas

pipe.

1. Place the metal cover plate over the

pipe.

2. Secure the plate with two screws.

1.8 Build-in gas hob GKM44

Prepare the cut-out in the worktop to

place the hob:

• The cut-out should be placed in the

center of the worktop where the

appliance is installed.

• Make the cut-out in the worktop

according to the dimensions

presented below. Too deep cut-out

must be corrected for example by a

wooden surround.

• Seal the cut surface with an

appropriate heat resistant sealant to

protect it from humidity.

• Preserve the minimal distances:

– 100 mm on any side to the

nearest piece of furniture,

– 100 mm at the back of the

worktop cut-out to the rear edge

of the worktop,

– 560 mm from the surface of the

hob to the piece of furniture /

appliance above it.

www.electrolux.com4

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários