Electrolux ERHC1238S Manual do Utilizador descarregar pdf (Página 4)

6 7

RANGEHOOD INSTALLATION (CONT) RANGEHOOD INSTALLATION (CONT)

If additional or alternative mounting points are required

there are 4 x M10 threaded mounting points on the top of

the hood as highlighted in the image below.

Model A B C D1 D2 D3 D4 D5 D6

ERHC938S 366mm 46mm 500mm 750mm 700mm 650mm 600mm 787mm

485mm

ERHC1238S 366mm 46mm 900mm 975mm 925mm 875mm 825mm 1085mm 485mm

WARNING!

Failure to install the screws or ﬁxing device in

accordance with these instructions may result in

electrical hazards.

4. Prior to installing the hood into position, x exhaust

transition duct using screws supplied, ensuring the

seal is between the rangehood top panel and the

base of the exhaust transition (Fig. D).

4a. If required, t the dampers and secure with clamps,

duct tape or cable ties.

Transition pieces

ERHC1238S - 1200mm model

Transition piece

screw holes (4 places)

Top of

cooker

Screws are to

be tightened

after the hood

is mounted on

the wall

Fig. D

Fig. B

Mounting

points

Anti-tilt

points

Min - See table

19mm max diameter

4mm

9mm max diameter

Max - See table

Rangehood

mounting point

detail

Mounting

screw detail

Fig. C

5. Mounting and securing the transition pieces is shown

in Fig. D.

WARNING!

Use screws provided to secure transition piece at

preformed holes. Using alternate screws and hole

locations may cause an electricl safety risk.

6. Hang hood on the mounting screws, tighten mounting

screws then secure at the anti-tilt locations as

indicated in Fig. B.

WARNING!

Due to product weight, take appropriate measures

to lift and position the product to avoid injury.

7. The canopy rangehood has been supplied with duct

transition piece/s, 200mm diameter non-combustible

ue pipe must be used with the transition piece/s.

Continue the centre line to the ceiling. Fit preferred

ue pipe to the fan transition duct (Fig. D1 & D2,

see page 11).

Use worm drive clamps, cable ties or suitable duct tape to

secure exible pipe to the transition duct.

NOTE: We recommend extending ﬂue pipe through the

roof to external roof cowl to vent exhaust externally.

We do not recommend venting into ceiling cavity.

NOTE: To ensure optimum performance of the

rangehood, the use of 200 mm diameter rigid ducting is

recommended. The use of bends should be avoided.

Rigid ﬂexible ducting is suitable, although loose ﬂexible

ducting is unacceptable. All ducting must be ﬁre retardant.

Electrical connection

Check that the installation complies with the standards

of local building, gas and electrical authorities. Before

connecting to the mains supply ensure that the mains

voltage corresponds to the voltage on the rating plate

inside the rangehood.

M10

1 2 3 4 5 6 7 8 9

Comentários a estes Manuais

Sem comentários

Electrolux ERHC1238S Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com não Electrolux ERHC1238S