Electrolux ERL-4E3WE Manual do Utilizador descarregar pdf (Página 10)

10 electrolux

Installation

ERL-4E3

1 When installing in combustible materi-

als, NIN 2000, section 4.2.2 and the fire

protection guidelines and the directives

of the Association for Cantonal Fire In-

surance (Verordnungen der Vereinigung

kantonaler Feuerversicherungen) must

be observed at all times.

1. Install hotplates in accordance with in-

stallation instructions 374 3079 00 or

374 3079 01 so that the hotplate plugs

can be plugged in before the built-in

cooker is slid in. Connect the hot-

plates properly. Separate earthing is

not required.

Install glass ceramic cooking surfaces

and hobs using separate installation in-

structions.

2. Drill the control panel fixing holes into

the recess floor using the enclosed tem-

plate (No. 374 2706 00) (cross mem-

ber). Fit screws (F) loosely with the

clamp.

3. In order to adjust the height of the panel

(only if necessary), the screws (D) on

either side of the control panel must be

removed. Undo screws (E), adjust the

height (+/- 10 mm possible) and tighten

again.

4. Slide the control panel into the recess so

that the securing clips are above the an-

gle brackets. Align the control panel and

tighten from underneath.

5. Caution! A second model plate must

stuck on so that it is clearly visible on the

dust and grease-free, cleaned inside

of the cabinet underneath (B) (see Elec-

trical Connection).

It must be possible to remove the recess

floor on site.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários