Electrolux EKK60331 Manual do Utilizador descarregar pdf (Página 6)

6 electrolux

The gas burner controls

To light a burner:

1. push the relevant control knob in

completely and turn it anticlockwise to

the maximum position (

);

2. upon ignition, keep the knob

pushed down for about 5 seconds.

This will allow the safety device

("thermocouple" - see figure 2, letter

D) to be heated and the safety device

to be switched off, otherwise the gas

supply would be interrupted;

3. then, check the flame is regular and

adjust it as required.

If the burner does not ignite, turn the

control knob to zero, and try again.

If after a few attempts the burner does

not ignite, check that the burner cap and

crown (see figure 2, letter A and B) are

correctly positioned.

To interrupt the supply of gas, turn the

knob in a clockwise direction to the position

"

".

When lighting the hob manually: Hold

a flame near the burner. Never turn the

control knob before approaching the burner

with the flame.

When switching on the mains,

after installation or a power cut, it

is quite normal for the spark

generator to be activated

automatically.

If you use a saucepan which is

smaller than the recommended

size, the flame will spread beyond

the bottom of the pan, causing the

handle to overheat.

As soon as a liquid starts boiling, turn

down the flame so that it will barely

keep the liquid simmering.

Fig. 1

))

))

)

Fig. 2

A - Burner cap

B - Burner crown

C - Spark generator

D - Thermocouple

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comentários a estes Manuais

Sem comentários