Electrolux EKG613A1OX Manual do Utilizador descarregar pdf (Página 25)

Assemble the burner in a revers

sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the

new gas type.

14.13 Adjusting the minimum

gas level on the oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven

functions. If there is no access to the

bypass screw dismount the control

panel before adjustment start.

3. With a thin and flat screwdriver adjust

the bypass screw A.

The model determines the position of

the bypass screw A.

A

Changing from natural gas to

liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

3. Connect the appliance to the

electricity.

Changing from liquid gas to

natural gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the oven functions

back.

3. Connect the appliance to the

electricity.

WARNING!

Put the mains plug into

the mains socket only if

all parts are back into

their initial position. There

is a risk of injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob for the oven functions

on the minimum position.

6. Remove the knob for the oven

functions again.

7. Screw on slowly the bypass screw till

the flame becomes minimum and

stable.

8. Put the knob for the oven functions

back.

9. Set the maximum gas flow position on

the knob for the oven functions and let

the oven heat for at least 10 minutes.

10. Quickly turn the knob for the oven

functions from maximum to the

minimum gas flow position.

Control the flame. Make sure the flame

does not go out when you turn the knob

to the minimum gas flow position. There

must be a small regular flame on the oven

burner crown. If the flame goes out adjust

the oven burner again.

14.14 Gas grill injector

replacement

1. Release the screws which keep the

grill burner in position A.

ENGLISH

25

1 2 ... 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários