Electrolux EHG75932X Manual do Utilizador

instruction bookletgas hobEHG 75932GB

10 electroluxBurner minimum maximumdiameter diameterDual burner 180 mm 300 mmLarge (rapid) 160 mm 260 mmMedium(rear semi-rapid) 120 mm 220 mmMedium(

electrolux 11Before any maintenance or cleaning can be carried out, youmust DISCONNECT the hob from the electricity supply.The hob is best cleaned wh

12 electroluxThe BurnersThe burner caps and crowns can be removed for cleaning.Wash the burners caps and crowns using hot soapy water, and removemarks

electrolux 13Something not working?If the hob is not working correctly, please carry out the following checksbefore contacting your local Service For

14 electroluxOVERALL dimensions Width: 744 mmDepth: 510 mmCUT OUT dimensions Width: 560 mmDepth: 480 mmSUPPLY CONNECTIONSGas:R 1/2 inch (1/2 inch male

electrolux 15NOMINAL NOMINALNOMINALBURNERTHERMAL REDUCEDFLOW RATETYPE POWER POWER NATURAL GAS LPG20 mbar28-30/37 mbarkW kW Nozzles

16 electroluxImportant safety requirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use)Regulations (Current Edit

electrolux 17InstallationIMPORTANTAny gas installation must be carried out by a GAS SAFEREGISTER installer.Please, ensure that, once the hob is insta

18 electroluxON/OFF SWITCHFLEXOUTLET2Building over a kitchen unitwith doorProper arrangements must be taken indesigning the furniture unit, in order t

electrolux 19Fitting the hob into the worktopCarry out the building in of the hob as follows:1. place the seals supplied withthe hob on the front edg

2 electrolux

20 electroluxElectrical connectionsAny electrical work required to install this hob should becarried out by a qualified electrician or competent perso

electrolux 21Permanent ConnectionIn the case of a permanent connection, it is necessary that you install adouble pole switch between the hob and the

22 electroluxWiring diagram

electrolux 23Fault findingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carr

24 electroluxA. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on W (Ohms)x 1 scale and adjust zero if necessary.— Test

electrolux 25Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity andearth continuity

26 electroluxCommissioningWhen the hob has been fully installed it will be necessary to check theminimum flame setting. To do this, follow the procedu

electrolux 27Conversion from natural gas to LPGIMPORTANTThe replacement/conversion from natural gas to LPG should only beundertaken by a competent pe

28 electrolux

electrolux 29

electrolux 3Welcome to the world of ElectroluxThank you for choosing a first class product from Electrolux, whichhopefully will provide you with lots

30 electrolux

electrolux 31

www.electrolux.co.uk39712-3402 04/09 R.A

4 electroluxContentsInstructions for the UserImportant safety information...

electrolux 5Important safety informationYou MUST read these warnings carefully before installing or using thehob. If you need assistance, contact our

6 electroluxKeep this instruction book for future reference and ensure it ispassed on to any new owner. When using the hob for a long period time, t

electrolux 7INSTALLATIONAny gas installation must be carried out by a registeredcompetent person, and in accordance with existing rules andregulation

8 electroluxHob burners control knobs The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas s

electrolux 9 After lighting the flame, keep the knobpushed down for about 5 seconds. Thiswill allow the "thermocouple" (Fig. 2 - lett.D) t