Electrolux EGT7657NOK Manual do Utilizador descarregar pdf (Página 14)

A B C

A. End of shaft with nut

B. Washer supplied with the appliance

C. Elbow supplied with the appliance

Connection to the gas supply should be

with either rigid or semi-rigid pipe, i.e.

steel or copper.

The connection should be suitable for

connecting to R 1/2 (1/2 BSP male

thread).

When the final connection has been

made, it is essential that a thorough leak

test is carried out on the hob and

installation.

Make sure that the main connection pipe

does not exert any strain on the hob.

If you use flexible metal pipes make sure

that they agree to ISO 10380 and ISO

10807 standards. Be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

CAUTION!

It is important to install the

elbow correctly, with the

shoulder on the end of the

thread, fitted to the hob

connecting pipe.

CAUTION!

Failure to ensure the correct

assembly will cause leakage

of gas.

CAUTION!

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

8.4 Electrical connection

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug (if applicable).

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of

fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the

cabinet, in order to avoid any contact

with the equipment beneath the

cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations.

For your own safety the installation must

be done by a qualified electrician (e.g.

your local Electricity Board, or a

contractor who is on the roll of the

National Inspection Council for Electrical

Installation Contracting [NICEIC]).

The manufacturer refuses

to be held responsible, if

these safety measures are

not abided by.

Supply connections

This hob has to be connected to 220-240

V (~ 50/60 Hz ) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

• or E — Earth terminal

Before carrying out the connection, make

sure:

1. The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2. The supply system is equipped with

an efficient earth connection in

compliance with the current

standards and regulations

3. The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

www.electrolux.com14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários