Electrolux EGG6242NOX Manual do Utilizador descarregar pdf (Página 13)

8.4 Adjustment of minimum level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

A

5. If you change:

• from natural gas G20/G25 20/25

mbar to liquid gas, fully tighten the

bypass screw in.

• from liquid gas to natural gas

G20/G25 20/25 mbar, undo the

bypass screw approximately 1/4 of

a turn.

• from natural gas G20/G25 20/25

mbar to town gas G130 8 mbar,

undo the bypass screw

approximately 3/4 of a turn.

• from town gas G130 8 mbar to

natural gas G20/G25 20/25 mbar,

tighten the bypass screw

approximately 3/4 of a turn.

• from liquid gas to town gas G130 8

mbar, undo the bypass screw

approximately 1 turn.

• from town gas G130 8 mbar to

liquid gas, fully tighten the bypass

screw in.

WARNING!

Make sure the flame does not

go out when you quickly turn

the knob from the maximum

position to the minimum

position.

8.5 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a

correct plug which can hold the load

that the rating plate rates. Make sure

that you install the plug in a correct

socket.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that the

ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

Make sure that you connect

the blue neutral cable to the

terminal with a letter "N" on it.

Connect the brown (or black)

phase cable to the terminal

which has a letter "L". Keep

the phase cable connected at

all times.

8.6 Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H05V2V2-F T90.

Make sure that the cable section is

applicable to the voltage and the working

temperature. The yellow / green earth wire

must be approximately 2 cm longer than

the brown (or black) phase wire.

8.7 Building In

min.

55 mm

min.

650 mm

560 mm

480 mm

min.

600 mm

30 mm

ENGLISH

13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comentários a estes Manuais

Sem comentários