Electrolux EGG3313NOX Manual do Utilizador descarregar pdf (Página 13)

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

8.4 Adjustment of minimum

level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

A

5. If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn (1/2 of

a turn for Triple Crown burner).

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

8.5 Replacing the power supply

cable

Use the same type of power supply

cable. This cable must be connected to

the terminal block following the diagram.

230V~

230V~

N

PE

L

If the power supply is

damaged it must be

substituted by a suitable

cable available in the after

sales service.

Connection to a good earth

wiring system is absolutely

essential. The manufacturer

accepts no responsibility for

any inconvenience caused

by failure to comply with this

rule.

If the power supply cable has to be

replaced, the gauge of the wires in the

new cable must be at least 0.75 mm² (3 x

0.75 cable), the earth wire (yellow-green)

must be at least 20 mm longer at the end

for connection to the appliance.

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H03V2V2-FT90.

Do not let the power cable to heat up to a

temperature higher than 90° C.

The cable must be replaced by a

qualified electrician, who must make the

mains connection as shown below.

• L — brown

• N — blue

•

— yellow-green

L N

20 mm

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários