Electrolux EGG3313NOX Manual do Utilizador descarregar pdf (Página 11)

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

– it can not get hot more than room tem-

perature, higher than 30°C;

– it is no longer than 1500 mm;

– it shows no throttles;

– it is not subject to traction or torsion;

– it does not get in touch with cutting

edges or corners;

– it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

– it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

– the material is not hardened, but shows

its correct elasticity;

– the fastening clamps are not rusted;

–expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a soapy

solution, not a flame!

8.2 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Techni-

cal Data" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.3 Conversion to town gas

G110 gas

• Triple Crown burner: after you assem-

ble the injectors (

3

in following figure),

screw their cages (diameter 16 mm,

2

in following figure) on, included in the

supply (primary air regulators) ;

2

1

3

Use the special cap tool

1

and a

screwdriver to secure the cages

and to prevent the damage to the

nuts.

Be sure to remove the cap tool

before reassembling the burners.

8.4 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the by-

pass screw position.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários