Electrolux EGG3313NOX Manual do Utilizador Página 1

EGG3313... ...EN HOB USER MANUAL

MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMODELMODELMOD.PROD.NO.SER.NO.03 ITMADE IN ITALYTYPE230V-50HzIP2000491 2 31Stick it on Guarantee Card and

Liquid gasUse the rubber pipe holder for liquid gas.Always engage the gasket. Then continuewith the gas connection.The flexible pipe is prepared for a

AA)The by-pass screw• If you change from natural gas G20 20mbar to liquid gas, fully tighten the by-pass screw in.• If you change from liquid gas to n

ABA)supplied sealB)supplied bracketCAUTION!Install the appliance only on aworktop with flat surface.8.8 Possibilities for insertionKitchen unit with d

Heat inputTriple Crown burner: 4.0 kWTOTAL POWER: G20 (2H) 20 mbar = 4.0 kWG30 (3B/P) 28–30 mbar = 291 g/hG31 (3B/P) 37 mbar = 286 g/hElectric supply:

ENGLISH 15

www.electrolux.com/shop397294901-A-332012

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY INSTRU

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible if

• Never try to extinguish a fire with water, but switch offthe appliance and then cover flame e.g. with a lid or afire blanket.• Do not store items on

nect the appliance from the mains at allpoles. The isolation device must have acontact opening width of minimum 3mm.• Use only correct isolation devic

• Do not clean the burners in the dish-washer.• Clean the appliance with a moist softcloth. Only use neutral detergents. Donot use abrasive products,

4.1 Ignition of the burnerWARNING!Be very careful when you useopen fire in kitchen environment.Manufacturer decline any respon-sibility in case misuse

WARNING!Make sure that the bottoms ofpots do not stand above the con-trol knobs. If the control knobs areunder the bottoms of pots, theflame heats the

7. TROUBLESHOOTINGProblem Possible cause RemedyThere is no spark whenlighting the gas• There is no electricalsupply• Make sure that the unitis connect