Electrolux WOK38TSIO Manual do Utilizador descarregar pdf (Página 19)

8.8 Installation of more than

one hob

Supplied accessories: connection bar,

heat-resistant silicone, rubber shape,

sealing stripe.

Use only a special heat-

resistant silicone.

The worktop cutout

Distance

from the

wall

minimum 50 mm

Depth 490 mm

Width sum of all widths of hobs

that you install minus 20

mm

Example:

580 mm

520 mm

490 mm

360 mm

+ - =

20 mm 920 mm

Assembly

1. Calculate correct cutout dimensions.

2. Prepare cutout in the worktop.

3. One by one place the hobs on a soft

surface (for example on a blanket)

with the bottom side up.

4. Attach the supplied seal stripe to the

lower edge of the hob along the outer

edge of the glass ceramic.

5. Loosely screw the fixing plates into

the correct holes in the protective

casing.

6. Insert first hob into the worktop

cutout. Than insert the connection

bar into the worktop cutout. Push it

half of its width under the hob.

7. Loosely screw in the fixing plates

from below to the worktop and to the

connection bar.

8. Insert next hob into the worktop

cutout. Make sure that the front

edges of the hobs are on the same

level.

9. Tighten the fixing plates / retaining

grip screws.

10. Use silicone to seal the gaps

between the hobs and between the

hobs and the worktop.

11. Put some soapy water on the

silicone.

12. Press the rubber shape with some

strength against the glass ceramic

and move it slowly along the space.

13. Do not touch the silicone until it

becomes hard, it can last about a

day.

14. Carefully remove the silicone that

came out with a shaving blade.

15. Clean the glass surface.

ENGLISH 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários