
Problem Possible cause Remedy
There is no signal when you
touch the panel sensor
fields.
The signals are deactivated. Activate the signals.
Refer to "Daily use" chapter.
The flexible induction cook-
ing area does not heat up
the cookware.
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the acti-
vated function or function
mode.
Refer to "Flexible induction
cooking area" chapter.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Use cookware with diame-
ter applicable to the activa-
ted function or function
mode. Use cookware with
diameter smaller than 160
mm on a single section of
the flexible induction cook-
ing area.
Refer to "Flexible induction
cooking area" chapter.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and ac-
tivate it again.
comes on.
The Child Safety Device or
the Lock function operates.
Refer to "Daily use" chapter.
comes on.
There is no cookware on
the zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips”
chapter.
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct
dimensions.
Refer to “Technical informa-
tion” chapter.
The cookware does not
cover the cross / square.
Cover the cross / square
fully.
FlexiBridge function oper-
ates. One or more sections
of the function mode which
operates are not covered
by the cookware.
Place the cookware on the
correct number of sections
of the function mode which
operates or change the
function mode.
Refer to "Flexible induction
cooking area" chapter.
ENGLISH
19
Comentários a estes Manuais