Electrolux EHP740X Manual do Utilizador descarregar pdf (Página 6)

6

Ceramic glass surface

The ceramic glass surface has four

cooking zones. When a zone is

turned on, it will illuminate at

various intervals depending on the

heat setting selected. Even at the

highest setting the zone is

disconnected occasionally to ensure

that the surface is not over-heated.

The glass is hard, and has been

tempered to withstand heat, cold

and temperature shocks. But like all

glass it is sensitive to impact. Do

not stand on the ceramic glass

surface.

At the front of the ceramic

glasssurface in the middle there are

four fields. Each field corresponds

to a cooking zone. When using a

zone, the field concerned will show

which CHEC function you are

using and the setting at which you

have set the zone.

Cooking zones

There are two single zones and two

double zones.

CHEC control

Information about how to use the

CHEC control function can be

found in the section entitled

“Operation instructions”. The

CHEC control function allows

electronic control of the zones.

CHEC control enables you to set

the heat with great precision, which

means that you do not have to

adjust the heat constantly. CHEC

control provides the zones with the

following functions:

Automatic disconnection of

“forgotten” zones.

AUTOMAX at all settings.

Setting of large zone on

double zones.

Child safety device on zones.

Residual heat indicator

When you switch off a zone, an

"H" in the display indicates that the

zone is still hot. The residual heat

indicator will continue to be

illuminated until the zone reaches a

temperature of approx. 80˚C.

23

Technical data

Cell Voltage 230 V

Electrical connection

230V - 50Hz

Total wattage 7400W

Instant heat effect

Left front 14/21 cm 1000/2200 W

Left Back 18 cm 1800 W

Right back 14 cm 1200 W

Right front 17/26,5 cm1400/2200 W

This unit is labelled to indicate

conformity with the lowvoltage directive

(73/23/EEC) and the EMC directive

(89/336/EEC).

Unpacking

Check that the hob has no faults and

is undamaged on delivery.

Transport damage

Any damage from transport which

you have not carried out yourself must

be reported to the retailer within one

week of receipt.

You will find the serial number of the

hobs the nameplate.

Write the serial number on the cover

of these operating instructions to make

it easy to find in case of service.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentários a estes Manuais

Sem comentários