Electrolux EWG147410W Manual do Utilizador

EWG 147410 W... ...EN WASHING MACHINE USER MANUAL

1. Set the washing machine to PAUSE bypressing button 8.2. Press button 6 once until the symbol 0’is displayed3. Press button 8 again to start the pro

INTERRUPTING A PROGRAMMEPress the button 8 to interrupt a pro-gramme which is running, the correspond-ing green pilot light starts blinking.Press the

dab the stain with the fingertips and a cot-ton cloth.Rust: oxalic acid dissolved in hot water or arust removing product used cold. Be carefulwith rus

WASHING PROGRAMMESProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergent Com-p

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergent Com-partment RINSESRins

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergent Com-partment WOOL40° -

CARE AND CLEANINGWarning! You must disconnect theappliance from the electricity supply,before you can carry out any cleaningor maintenance work.DESCAL

2. Run a washing cycle without any wash-ing to clean off any cleaning agent resi-dues.Programme: Short Cotton Programmeat maximum temperature and add

6. Remove foreign bodies and fluff fromthe filter seat and from the pump impel-ler.Check carefully whether the pump im-peller rotates (it rotates jerk

5. When no more water comes out, un-screw the pump cover (A) by turning itanti-clockwise and remove the filter.Use pliers, if necessary. Always keep a

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Safety instructions 3Product description

Important! Every time you drain the waterthrough the emergency emptying hose youmust pour 2 litres of water into the mainwash compartment of the deter

Problem Possible cause/SolutionThe washing machine does not start:The door has not been closed. • Close firmly the door.The plug is not properly inser

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent(creates too much foam) has been used.• Reduce th

Problem Possible cause/SolutionThe machine makes an unusual noise:The machine is fitted with a type of motor whichmakes an unusual noise compared with

Programmes Load(kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approximateprogrammeduration (mi-nutes)Remainingmoisture(%)1)Standard cotton pro

4. Slide out the relevant plastic spacers.5. Fill the smaller upper hole and the twolarge ones with the corresponding plas-tic plug caps supplied in t

2. Connect the hose with the angled con-nection to the machine. Do not placethe inlet hose downwards. Angle thehose to the left or right depending ont

This means that they can be recycled bydisposing of them properly in appropriatecollection containers.ECOLOGICAL HINTSTo save water, energy and to hel

Fig. 412c) Mounting the doorFix the hinges to the appliance by means ofthe M5x15 screws. The hinges can be ad-justed to compensate for possible uneven

electrolux 29

• Obey the maximum load volume of 7 kg (refer to the “Pro-gramme chart” chapter).• If the supply cord is damaged, it must be replaced by themanufactur

30 electrolux

electrolux 31

www.electrolux.com/shop 132924381-A-502012

• Before you connect the appliance to newpipes or pipes not used for a long time,let the water flow until it is clean.• The first time you use the app

DETERGENT DISPENSER DRAWER Compartment for detergent used forprewash and soak phase or for stain re-mover used during the stain action phase (ifavaila

10TIME MANAGER buttons PROGRAMME SELECTOR DIALIt allows you to switch the appliance on/offand/or to select a programme.TEMPERATUREThis button allows y

DISPLAY7.4 7.5 7.17.27.3The display shows the following informa-tion:7.1:•Duration of the selected programmeAfter selecting a programme, the durationi

fault). By pressing these 2 buttons again,the acoustic signal is reactivated.CHILD SAFETY LOCKThis device permits you to leave the appli-ance unattend

SELECT THE REQUIRED PROGRAMMEBY TURNING THE PROGRAMMESELECTOR DIAL (1)Turn the programme selector dial to the re-quired programme. The washing machine