Electrolux TCW1990 Manual do Utilizador

820 41 72 58USERUSERs MANUs MANUAL - AL - NONOTICE DUTILISTICE DUTILISAATION -TION -MANUMANUAL DEL USUAL DEL USUARIOARIOTCW 1990ICE LINING REFRIGE

101. Open the lid of the appliance. Unscrew the the lidballast container. (fig. 11)2. Unscrew the cap of the lid ice accu and fil it with cleanwater.3

118. Fill the ice-packs to the marked level and screw onthe cap. To remove the cap, you press on the capfrom the top and simultaneously you turn the c

121. Close the lid and plug in the appliance. The greenindicator light on the front control panel shows youthat the unit is switched on. (fig. 17)2. T

13DEFROSTING & CLEANINGThe moisture in the air, which enters the ILR due to lidopening (and also may be due to defective lid-gasketor door alignme

145. DEFROSTING & CLEANING5.Unscrew the plastic innerliner and remove them.6.Remove all the ice-packs and store them in a transportbox, so that th

15DAILY1.Take temperature readings from the thermometersand note down the temperature and the time ofreading.Keep the temperature records systematical

16IMPORTANT:When an ILR is found to be not working at all or notworking properly, see that the vaccine temperature iswithin the recommended limits. Do

174.If the compressor is observed to be runningcontinuously but no cooling is attained - this may bedue to leakage of refrigerant gas from the system

18IF THE ILR IS TO BE SHUT DOWN FORTRANSPORTATION ETC.Disconnect the power-supply plug from socketAllow the ice in the liner tuber (if any) to melt an

19

USER MANUAL2ICE LINING REFRIGERATOR FREEZERHandleLid ice accuRubber gasketData labelThermometer85010506301465CompressorcompartmentPilot lamp ONThermos

1. GENERAL INFORMATION ...page 42. INSTALLATION ...

THE ILROne of the most important links in the cold-chain is IceLining Refrigerator (ILR). This is a unit which operateson the principle of vapour comp

Check the manufacturer's plate, at the back of the ILRand make sure that the ILR has correct voltage forlocal supply, i.e. 1 15 or 230 volts (fig

3.EXAMINE the compressor compartment (fig. 3;Check carefully for any damage, dislocation orlooseness etc. of the components, specially atlocations A,

LOCATION B (fig. 5)Check that the incoming electrical connections of thepower supply cord to the terminal strip are tight.LOCATION C (fig. 6)Check tha

84.Refit side cover of the compressor compartment intoposition refixing the screws holding the side cover (fig. 8)5.INSTALL firmly the ILR on a levelf

97.Connect the leads of the power supply cord to asuitable 3-pin plug as shown below (fig. 10)Lead of cord Pin of plug Green/yellow Earth Blue Neutral