Electrolux EA3200 Manual do Utilizador descarregar pdf (Página 6)

3. Ventilation must be provided as shown in

alternatives A, B, C or D (fig 2-3)

4. The ventilation duct must at least measure

105mm x the width of the refrigerator

5. Only

the entire cooling unit must project into

the duct as shown

6. Air passing through the duct must not be

preheated by any source of heat

7. Ventilation grills, if used, must have openings

of at leas

t 200cm

each

During installation, please ensure the mains plug

is accessible at all times.

5. Using the appliance

To start the refrigerator connect the plug to the socket

outlet and switch on the socket. The cooling fins

should show signs of cooling after about 3 hours.

The refrigerator needs about 6 hours at normal

ambient temperature to reach 6 °C in the storage

compartment.

5.1. Temperature regulation

The usual setting required is in middle of the setting

range on the thermostat knob (Fig. 4-6), but this can

vary with conditions of load and installation. If it is

found necessary to alter the setting,the knob can be

turned to a higher number to produce a colder

temperature, or a lower number to produce a warmer

temperature. The effect of any adjustment can be

checked by means of a thermometer after leaving the

refrigerator operating for a further period to settle

down again.

Figure 3.

Figure 4.

Figure 6.

Figure 5.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Electrolux EA3200 Manual do Utilizador Página 6