Electrolux Chest freezers Manual de Serviço descarregar pdf (Página 85)

NOTE: If low-side process tube is too short, silver

solder four inch piece of tubing onto

process tube at this time.

10. Solder all connections.

13. Replace the original filter-drier.

CAUTION: DO NOT un-braze old filter-drier from

system. This will vaporize and drive

moisture from desiccant back into

system. The old filter-drier should be

cut out of system.

15. Evacuate and charge system using recommended

procedure described under Evacuating and

Recharging.

Replacing the Condenser:

The condenser is foamed in place and is not accessible

for repair. However, repair can be made by installing a

service replacement condenser kit. Refer to the appro-

priate part list of the model been service for the correct

kit part number.

Each service replacement condenser kit consists of: a

condenser assembly that can be installed on the back

of the cabinet, mounting hardware, replacement filter-

drier and a complete installation instructions.

To install, use the following procedure:

1. Disconnect unit from source of power.

2. Recover refrigerant by using EPA approved recovery

system.

3. Installed the replacement condenser in accordance

with the instructions included with the kit.

4 Evacuate and charge a system using the

recommended procedure described under

evacuation and recharging found in section D.

1 2 ... 80 81 82 83 84 85 86 87 88

Sem comentários

Electrolux Chest freezers Manual de Serviço Página 85