Electrolux E15IM60EPS Especificações

InstallationINSTALLATION DIMENSIONS14 - 15/16”(37.9)24”(61)21 - 3/4”(55.2)34 - 1/8”(86.7)FULLRETRACTHEIGHTWATERVALVEWATEROUTLETWATERDRAIN5”(12.7)Figur

SCREWPLUGSFigure 13Figure 14Figure 15Door ReversalREVERSING THE DOOR (SOME MODELS)All Electrolux units may be left or right hand opening. The dooropen

Door Reversal3 Remove top hinge (3 screws), reinstall hinge screw pin, andremount on opposite side BOTTOM (see Figure 17).4 Remove the two door closer

!CACACACACAUTIONUTIONUTIONUTIONUTIONPLEASE READ all instructions completely before attempting to install or operate theunit. All ice makers require a

91 Make certain the unit is not plugged into an electricaloutlet.2 Carefully push the power cord grommet through the holein the back panel. See Figure

10Drain Pump ConnectionCONNECTING A DRAIN PUMPIf a gravity drain connection is not available, and you have not purchased theE15IM60E with factory inst

Site PreparationPREPARING THE SITE1 Position the unit on a flat, level surface, capable of supporting the entireweight of the unit. Remember that the

12Site Preparation6 Install and connect the water supply line. SeeConnecting the Water Supply for installationrequirements.7 Position the unit to allo

Water Supply ConnectionCONNECTING THE WATER SUPPLYWhen connecting the water supply, follow these guidelines:• Review the local plumbing codes before y

!CACACACACAUTIONUTIONUTIONUTIONUTIONAfter completing the installation, turn on the water andrecheck water and drain connection for leaks. Applyadditio

LevelingLEVELING THE UNIT1 Use a level to check the levelness of the ice makerfrom front to back and from side to side (see Figure11).2 If the ice mak