Electrolux GK78TSIPO Manual do Utilizador descarregar pdf (Página 17)

One-phase connection

1. Remove the cable end sleeve from

black and brown wires.

2. Remove an insulation of the brown

and black cable ends.

3. Apply a new wire end sleeve of 2.5

mm² on common cable end. (special

tool required).

Cable cross section

230V~ 400V 2~N

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N

Green - yellow Green - yellow

N Blue and grey Blue and grey N

L Black and brown Black L1

Brown L2

8.5 Attaching the seal to the

rabbet

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an angle

of 45°. They should fit in the corners

of the rabbets accurately.

4. Attach the stripes to the rabbets. Do

not extend the stripes. Do not bond

ends of stripes one over another.

After you assemble the hob, seal the

remaining gap between glass ceramic and

the worktop with silicone. Make sure the

silicone does not get under the glass

ceramic.

8.6 Attaching the seal

1. Clean the worktop around the cut out

area.

2. Attach the supplied seal stripe to the

lower edge of the hob along the outer

edge of the glass ceramic. Do not

extend it. Make sure that the ends of

the seal stripe are located in the

middle of one side of the hob.

3. Add some mm when you cut the seal

stripe to the length.

4. Push the two ends of seal stripe

together.

ENGLISH

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Electrolux GK78TSIPO Manual do Utilizador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Electrolux GK78TSIPO