Electrolux ETIH3022EMB Manual do Utilizador descarregar pdf (Página 25)

Troubleshooting

Before calling the service centre, review this list.

Problem Possible cause and solution

You cannot activate the

appliance or operate it.

You put something on one or more sensor fields. Remove the

object from the sensor fields.

Activate the appliance again and set the heat setting in 10

seconds.

You touched 2 or more sensor elds at the same time. Only touch

one sensor field.

The Child Safety Device or the Lock or Stop+Go operates. See

the chapter Operating instruction.

There is water or fat stains on the control panel. Clean the

control panel.

A Sound operates and the

appliance deactivates.

A sound operates when the

appliance is deactivated.

The appliance deactivates.

You put something on the . remove object from the sensor

field.

The residual heat indicator

does not comes on.

The cooking zone is not hot because it operated only for a short

time. If the cooking zone should be hot, speak to the service

centre.

The Automatic Heat Up

function does not operate.

There is still residual heat on the cooking zone. Let the

cooking zone become sufficiently cool.

The highest heat setting is set. The highest heat setting has

the same power as the Automatic Heat Up function.

The heat setting changes

between two levels.

The sensor fields become hot.

The Power management is activated. See the section Power

management.

The cookware is too large or you out it too near to the

controls. Put large cookware on the rear cooking zones if it is

necessary.

comes on

The Automatic Switch Off operates. Deactivate the appliance

and activate it again.

No cookware on the cooking zone. Put cookware on the

cooking zone.

Not correct cookware. Use the correct cookware.

The diameter of the bottom of the cookware is too small for the

cooking zone. Move cookware to a smaller cooking zone.

comes on

There is an error in the appliance.

Disconnect the appliance from the electrical supply for some

time. Disconnect the fuse from the electrical system of the

house. Connect again. If comes on again, speak to the

service centre.

comes on

There is an error in the appliance, because a cookware boils dry.

The protection against become too hot for the cooking zone

operates. The Automatic Switch Off operates. Deactivate the

appliance. Remove the hot cookware. After, approximately 30

seconds activate the cooking zone again.

E4 should go out of the display, residual heat indicator can stay.

Let the cookware become sufficiently cool and check it with the

section Cookware for the induction cooking zone.

If you tried the above solutions and cannot repair the problem, speak to your

dealer or the customer service. Give the data from the rating plate, three digit

letter code for the glass ceramic (it is in the corner of the glass surface) and an

error message that comes on.

Make sure, you operated the appliance correctly. If not the servicing by a

customer service technician or dealer will not be free of charge, also during

the warranty period.

Possible cause and solution

Problem

47 electrolux troubleshooting

troubleshooting electrolux 48

ENG

1 2 ... 20 21 22 23 24 25 26

Comentários a estes Manuais

Sem comentários

Electrolux ETIH3022EMB Manual do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Electrolux ETIH3022EMB