
3
Hob Burners Control Knobs
The hob burners control knobs are situated on the hob
front panel. The symbols on the knobs mean that :
z there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the Burners
• For easier lighting, proceed before putting a pan
on the pan support.
• Push the relevant knob down and turn it anti-clockwise
until it reaches the "maximum" position ( ).
• After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the "thermocouple"
(Fig. 1 - lett. D) to be heated and the safety device to
be switched off, otherwise the gas supply would be
interrupted.
• Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several attempts,
check the "cap" (Fig. 1 - lett. A) and the "crown" (Fig.
1 - lett. B) are in the correct position. To put the flame
out, turn the knob to the symbol z.
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
• In the absence of electricity, ignition can occur without
the electrical device; in this case approach the burner
with a flame, push the relevant knob down and turn it
anti-clockwise until it reaches the "maximum" position.
• Always turn the flame down or put it out before
taking the pans off the burner.
Contents
This appliance complies with the following
E.E.C. Directives:
- 73/23 - 90/683 (Low Voltage Directive);
- 89/336
(Electromagnetical Compatibility Directive);
- 90/396 (Gas Appliances)
- 93/68 (General Directives)
and subsequent modifications.
MANUFACTURER:
ELECTROLUX HOME PRODUCTS ITALY S.p.A.
Viale Bologna 298 - 47100 FORLI’ (Italy)
Instruction for the User
Important Safety Information 2
Instruction for the User 3
Maintenance and Cleaning 5
Service and original spare parts 6
Technical Data 6
Instruction for the Installer 7
Electrical connection 8
Adaptation to different types of gas 9
Building In 10
For the User For the Installer
))
))
)
Fig. 1
FO 0204
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
A
B
D
C
triple crown burner
Comentários a estes Manuais