Electrolux EHD6690X45C Manual do Utilizador descarregar pdf (Página 25)

1 IMPORTANT!

Risk of injury from electrical current.

Loose and inappropriate plug and socket connections can make the ter-

minal overheat.

• Have the clamping joints correctedly installed by a qualified electri-

cian.

• Use strain relief clamp on cable.

• In the event of single-phase or two-phase connection, the appropri-

ate mains cable of type H05BB-F Tmax 90° (or higher) must be used.

• If this appliance’s mains cable is damaged, it must be replaced by a

special cable (type H05BB-F Tmax 90°; or higher). The latter is availa-

ble from the Customer Care Department.

A device must be provided in the electrical installation which allows the

appliance to be disconnected from the mains at all poles with a contact

opening width of at least 3 mm

Suitable isolation devices include line protecting cut-outs, fuses (screw

type fuses are to be removed from the holder), earth leakage trips and

contactors.

Appliance dimensions

Installation proud of the work surface

• Clean the worktop in the area of the cut-out section.

• Stick the one-sided self-adhesive sealing tape supplied all the way

round the lower edge of the cooking surface along the outer edge of

the glass ceramic panel. Do not stretch it. The cut ends should lie in

the middle of one side. When you have cut it to length (add a few

mm), press the two ends flush up against one another.

Width 590 mm

Depth 520mm

Height 55mm

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Sem comentários

Electrolux EHD6690X45C Manual do Utilizador Página 25