
CARE AND CLEANING
Clean the appliance after each use.
Always use cookware with clean bottom.
Warning! Sharp objects and abrasive
cleaning agents will damage the
appliance.
For your safety, do not clean the appli-
ance with steam blasters or high-pres-
sure cleaners.
Scratches or dark stains on the glass
ceramic have no effect on how the ap-
pliance operates.
To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to the
appliance. Use a special scraper for
the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
–
Remove after the appliance is suf-
ficiently cool: limescale rings , water
rings, fat stains, shiny metallic discol-
orations. Use a special cleaning agent
for glass ceramic or stainless steel.
2. Clean the appliance with a moist cloth
and some detergent.
3. At the end rub the appliance dry with
a clean cloth.
WHAT TO DO IF…
Problem Possible cause and remedy
You cannot start the appliance
or operate it.
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• There is water or fat stains on the control panel. Clean the con-
trol panel
•
The child safety device or key lock or
operates. See the
chapter Operating the appliance.
• Start the appliance again and set the heat setting in 10 sec-
onds.
A sound operates when the ap-
pliance is off.
You covered one or more sensor fields. Uncover the sensor
fields.
The residual heat indicator
does not come on.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone is supposed to be hot, speak to the Af-
ter Sales Service.
Heat setting alternates The Power management is active. See the section Power man-
agement.
A sound operates and appli-
ance starts and stops again.
After 5 seconds one more
sound operates.
You covered . Uncover the sensor field.
comes on
• The automatic switch-off operates. Stop the appliance and
start it again.
Overheating protection for the cooking zone operates. Switch off
the cooking zone. Switch on the cooking zone again.
comes on
• No cookware on the cooking zone. Put cookware on the cook-
ing zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the
cooking zone. Move cookware to a smaller cooking zone.
10 electrolux
Comentários a estes Manuais