Electrolux EGU6647LOX Manual do Utilizador descarregar pdf (Página 15)

To replace the connection

cable use only H05SS-F

T180 or equivalent type.

Make sure that the cable

section is applicable to the

voltage load and the working

temperature. The yellow/

green earth wire (B) must be

approximately 2 cm longer

than the live and neutral wire

(A).

A B

1. Connect the green and yellow (earth)

wire to the terminal which is marked

with the letter 'E', or the earth symbol

, or coloured green and yellow.

2. Connect the blue (neutral) wire to the

terminal which is marked with the

letter 'N' or coloured blue.

3. Connect the brown (live) wire to the

terminal which is marked with the

letter 'L'. It must always be connected

to the network phase. There must be

no cut or stray strands of wire present.

The cord clamp must be correctly

attached to the outer sheath.

8.6 Building In

min. 600 mm

min. 55 mm

min. 650 mm

560 mm

490 mm

min. 100 mm

30 mm

CAUTION!

Install the appliance only on a

worktop with flat surface.

8.7 Possibilities for insertion

The panel installed below the hob must be

easy to remove and let an easy access in

case a technical assistance intervention is

necessary.

The burner flame may be

extinguished by an air flow, if

the removable panel is not

installed. The air flow may

occur when you open or

close the cabinet door or

drawer.

ENGLISH

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários