Electrolux EGC3322NOK Manual do Utilizador descarregar pdf (Página 12)

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the ad-

justment screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.4 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a cor-

rect plug which can hold the load that

the rating plate rates. Make sure that

you install the plug in a correct socket.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• There is a risk of fire when the appli-

ance is in connection with an extension

cable, an adapter or a multiple connec-

tion. Make sure that the ground con-

nection agrees with the standards and

regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

To prevent contact between the cable

and the appliance below the hob use the

clamps which are on the side of the cabi-

net.

A

A)

Rigid copper pipe or flexible pipe of

stainless steel

8.5 Replacement of the

connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown

(or black) phase wire.

8.6 Building in

30 mm

55 mm

40-50 mm

min. 650 mm

490 mm

min. 450 mm

270 mm

If several 30 cm hobs are to be installed

side by side into the same cut out, an as-

sembly kit including a support side brack-

et and supplementary seals is available at

our Service Centres. The relevant installa-

tion instructions are supplied within the kit

package.

270

+1

mm

R 5mm

min.

55mm

490

+1

mm

12

www.electrolux.com

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários