Electrolux EBSL80SP Manual do Utilizador descarregar pdf (Página 22)

45°

3.

Close the door until it is at an angle

of approximately 45°.

4.

Hold the door with one hand on each

side and pull it away from the appli-

ance at an upwards angle.

Put the door with the outer side

down on a soft and level surface

to prevent scratches.

5.

Now you can remove the inner glass

panels and clean them.

Inserting the door

To insert the door do the above steps in

the opposite sequence.

2

B

1

Removing and cleaning the door

glasses

The door has 2, 3 or 4 panels of

glass (depends on the model).

CAUTION!

Rough handling of the glass, es-

pecially around the edges of the

front panel, can cause the glass to

break.

1.

Hold the door trim (B) on the top

edge of the door at the two sides and

push inwards to release the clip seal.

2.

Pull the door trim to the front to re-

move it.

3.

Hold the door glass panels on their

top edge one by one and pull them

upwards from the guide.

4.

Clean the door glass panels.

To install panels do the above steps

in the opposite sequence. Install the

smaller panel first, and then the larger

one.

11.4 Lamp

WARNING!

Danger of electrocution! Discon-

nect the fuse before you replace

the lamp.

The lamp and the lamp glass cov-

er can be hot.

Before you change the lamp:

• Deactivate the appliance.

• Remove the fuses from the fuse box or

deactivate the circuit breaker.

CAUTION!

Put a cloth on the bottom of the

interior of the appliance. It pre-

vents damage to the lamp glass

cover and the cavity.

Always use the same lamp type.

Replacing the top lamp:

1.

Turn the lamp glass cover counter-

clockwise to remove it.

22

www.electrolux.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comentários a estes Manuais

Sem comentários