
13
Instruction for the User
Hob burners control knobs
The hob burners control knobs are situated on the hob
lateral panel. The symbols on the knobs mean that :
l there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a pan on
the pan support.
l To light a burner, push in the relevant control
knob and turn it anti-clockwise to "maximum"
position.
l Upon ignition, keep the knob pushed down for
about 5 seconds. This will allow the
"thermocouple" (Fig. 1 lett. D) to be heated and
the safety device to be switched off, otherwise
the gas supply would be interrupted.Then,
check the flame is regular and adjust it as
required.
l If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 lett. A) and
the "crown" (Fig. 1 lett. B) are in the correct
position.
l To put the flame out, turn the knob to the
symbol l.
Always turn the flame down or put it out
before taking the pans off the burner.
Using the hob correctly
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a flat
bottom fitting the size of the burner used, so that flame will
not spread beyond the bottom of the vessel (see the table
beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
Carefully supervise cookings with fats or oil,
since these types of foodstuff can result in a
fire, if over-heated.
Burner minimum maximum
diameter diameter
Big (rapid) 180 mm. 260 mm.
Medium (semirapid) 120 mm. 220 mm.
Small (Auxiliary) 80 mm. 160 mm.
Fig. 1
FO 0204
F
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
For the user
For Your Safety 12
Instruction for the User 13
Cleaning and Maintenance 14
Contents
For the installer
Technical Data 15
Gas connection 15
Electrical Connection 16
Adaptation to different types of gas 17
Building in 18
Comentários a estes Manuais