
A
3. Using the adjustable feet, raise the front
of the unit so it leans back slightly, this will
assist in door closing. Make final adjust-
ments to ensure that the doors are cor-
rectly aligned.
D
B
C
A
A When the left door is raised.
B When the right door is raised.
C Lower the foot at right side until the
adjustable food on the other side is
slightly off ground.
D Lower the foot at left side until the
adjustable food on the other side is
slightly off ground.
4. Remove the 4 screws (A,C) from the bot-
tom of the refrigerator and use these to fit
the kickplate (B) (supplied inside the re-
frigerator compartment).
ABC
5. Connect the power plug to a 240 volt 10
amp power point.
Important!
• Position your refrigerator so that the plug
is accessible.
• Keep your refrigerator out of direct sun-
light.
• Do not place next to a heat generating ap-
pliance.
• This refrigerator is designed for indoor use
only – do not place the unit on an unsealed
surface.
• To avoid vibration and misalignment of the
doors, the unit must be level. Place the unit
on a solid flat surface. Uneven floors eg.
slate, tiles and floorboards, can cause the
unit to sag over time causing the doors to
become misaligned.
• If the mains power is switched on when the
door is open, the door alarm will sound.
Close the door to stop the alarm.
When transporting
• Using the rollers, it is possible to move
back and forth. Carry the refrigerator by
holding the holding devices located on the
rear and bottom.
Before using your refrigerator
• Clean the inside parts with a cloth soaked
in warm water. If soapy water is used, wipe
it off thoroughly.
electrolux 67
Comentários a estes Manuais