Electrolux ESL4201LO Manual do Utilizador

ESL4201LOEN Dishwasher User Manual

• The indicator shows thecurrent setting: indicator off =Acoustic signal off.3. Press the programme button tochange the setting.• indicator on =

7.1 The salt containerCAUTION!Use rough salt designed fordishwashers only. Fine saltincreases the risk ofcorrosion.The salt is used to recharge the re

8. DAILY USE1. Open the water tap.2. Press the on/off button to activate theappliance.Make sure that the appliance is inprogramme selection mode.• If

Make sure that there is detergent in thedetergent dispenser before you start anew programme.End of the programmeWhen the programme is completed theind

• Put hollow items (cups, glasses andpans) with the opening facingdownwards.• Make sure that glasses do not toucheach other.• Put light items in the u

2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).4. Wash the filters.5. Make sure that there are no residuesof food or soil i

11. TROUBLESHOOTINGIf the appliance does not start or it stopsduring operation, before you contact anAuthorised Service Centre, check if youcan solve

Problem and alarm code Possible cause and solutionSmall leak from the appliance door. • The appliance is not levelled. Loosen ortighten the adjustable

Problem Possible cause and solutionThere are whitish streaks orbluish layers on glasses anddishes.• The release quantity of rinse aid is too much. Ad‐

Problem Possible cause and solutionDull, discoloured or chippedtableware.• Make sure that only dishwasher-safe items arewashed in the appliance.• Load

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...

13. ADDITIONAL TECHNICAL INFORMATIONDimensions Width / height / depth (mm) 446 / 818 - 898 / 550Electrical connection 1)Voltage (V) 220 - 240Frequency

ENGLISH 21

www.electrolux.com22

ENGLISH 23

www.electrolux.com/shop156912241-A-492018

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible f

• The operating water pressure (minimum andmaximum) must be between 0.5 (0.05) / 8 (0.8) bar(MPa)• Obey the maximum number of 9 place settings.• If th

• Make sure not to cause damage tothe mains plug and to the mainscable. Should the mains cable need tobe replaced, this must be carried outby our Auth

3. PRODUCT DESCRIPTION4379 8 105611 121Upper spray arm2Lower spray arm3Filters4Rating plate5Salt container6Air vent7Rinse aid dispenser8Detergent disp

4.1 IndicatorsIndicator DescriptionEnd indicator.Salt indicator. It is always off while the programme operates.5. PROGRAMMESThe order of the programme

5.1 Information for testinstitutesTo receive the necessary information forconducting performance tests (e.g.according to EN60436), send an emailto:inf

Water hardnessGerman de‐grees (°dH)French de‐grees (°fH)mmol / l Clarke de‐greesWater softenerlevel47 - 50 84 - 90 8.4 - 9.0 58 - 63 1043 - 46 76 - 83